In the same vein, many 3-D printing enthusiasts would agree too much tinkering with the settings will end up with you in over your head. It is recommended to tweak settings to help improve the quality of your 3-D prints. Printing at low speeds (under 30 mm/s) can also deform the print Optimizing the Speed of Your Anet A8.Printing at high speeds (over 60 mm/s) can induce warping and fraying of the product.The optimal speed will vary from project to project, but a good rule of thumb will be to keep print speeds under 150 mm/s and hover around the 20 mm/s mark on the low end.Īttempting to go higher than 150 mm/s may produce undesirable results and it is recommended to stay under 60 mm/s. Patience is key when determining the ideal print speed of an Anet A8. Before you begin configuring speed settings it’s beneficial to see what other 3-D printing enthusiasts have experienced with their own configurations. Since 3-D printing is growing in popularity, a lot of new hobbyists have laid the groundwork for mishaps. You never know if their Anet A8 has been modified in a way that allows for such speeds.Īnecdotal evidence can also be a helpful tool in determining what speed is best. Be wary of anecdotal evidence, there is a lot of it. More experienced 3-D printing hobbyists may push the limits of their Anet A8 with speeds upwards of 200 mm/s. If you are new to 3-D printing and are just configuring your Anet A8 for the first time, take extra care when choosing speeds. Table of Contents Selecting a Print Speed

Hemera print speed